Plate-boundary fault rupture during the 2004 Sumatra-Andaman subduction earthquake extended closer to the trench than expected, increasing earthquake and tsunami size. International Ocean Discovery Program Expedition 362 sampled incoming sediments offshore northern Sumatra, revealing recent release of fresh water within the deep sediments. Thermal modeling links this freshening to amorphous silica dehydration driven by rapid burial-induced temperature increases in the past 9 million years. Complete dehydration of silicates is expected before plate subduction, contrasting with prevailing models for subduction seismogenesis calling for fluid production during subduction. Shallow slip offshore Sumatra appears driven by diagenetic strengthening of deeply buried fault-forming sediments, contrasting with weakening proposed for the shallow Tohoku-Oki 2011 rupture, but our results are applicable to other thickly sedimented subduction zones including those with limited earthquake records.
It is generally accepted that during the Mesozoic NE−NNE-trending folds overprinted E−W-trending folds to form the Longshan dome in the central South China continent, although the interference map does not tell the relative ages of the fold sets. In an effort to deepen our understanding of the process of reworking the continent, paleostress analysis using calcite twins was carried out in this study to verify or falsify this model. Ten limestone samples were collected from Upper-Paleozoic limestones on the flanks of the dome and were measured using the universal stage for calcite e-twins. E-twins in the samples are divisible into two kinds, thick (≥1 μm) and thin (<1 μm), indicative of relatively higher and lower deformation temperatures, respectively. Stress estimates obtained using the improved version of Shan et al.’s (2019) method were grouped into two layer-parallel shortening (LPS) subsets and three non-LPS subsets. These subsets comprise four tectonic regimes: NWW−SEE compression (LPS1 and non-LPS1), NNE−SSW compression (LPS2 and non-LPS2), NW−SE extension (non-LPS3a) and NNE−SSW extension (non-LPS3b). They were further arranged in a temperature-decreasing order to establish a complex deformation sequence of the study area. In the sequence NE−NNE-trending folds have an older age than E−W-trending folds, something different from the model. The approximately N−S regional compression responsible for the former folds should have a profound effect on the intensely deformed continent, something ignored in earlier work.
Abstract: Numerous structures and textures, which can be related to magma flow, were observed in felsic dykes intruding late Mesozoic granitoid plutons in the Jiaodong peninsula, in eastern Shandong province, eastern China. These flow structures may be classified into two categories, interior and peripheral. The former group includes magmatic bands, various types of folds (e.g. injection, sheath, similar and disharmonic folds), rotation of phenocrysts, magmatic foliation or lineation, and crenulation, whereas the latter includes hot tool marks and quarrying structures. Magmatic banding resulted from shearing of mingled magma during magma flow in the dykes. The magma seemed to flow rapidly, probably triggering turbulence in some thick dykes. Interaction at the contact between the hot, moving magma and the cold, stationary wallrock sometimes produced the peripheral structures. A few measurements of hot tool marks and of magmatic lineation reveal a roughly horizontal flow of magma within these dykes. For the dominant NE–SW-striking dyke set in the Laoshan granitoid pluton, the felsic magma probably ascended on or to the SW of the pluton to feed the dyke swarm, and then flowed laterally to drive the horizontal propagation of dykes.
Table S1. Relative abundances of non-opaque detrital heavy minerals in the Miocene formations from Hengchun Peninsula and Western Foothills. Abbreviations: Zrn—zircon, Tur—tourmaline, Rt—rutile, Ant—anatase, Ap—apatite, Mnz—monazite, Grt—garnet, Ep—epidote, Amp—amphibole, Spl—spinel, Px—pyroxene, R—rare (<0.05%). Table S2. Major element compositions of sedimentary rocks from the Hengchun Peninsula accretionary prism, southernmost Taiwan Table S3. Trace element compositions of sedimentary rocks from the Hengchun Peninsula accretionary prism, southernmost Taiwan (post-Archaean Australian Shale from Taylor and McLennan, 1985). Table S4. Whole-rock Nd isotopic compositions of the mud matrix of the Kenting Mélange in the Hengchun Peninsula accretionary prism.
The Ulgen porphyry Mo deposit, recently discovered in the northeastern segment of the Derbugan metallogenic belt, NE China, is a large and hidden ore deposit. Investigation of this deposit provides insights into the geodynamic background and metallogenic mechanism of Mesozoic porphyry Mo deposits that are exposed elsewhere in NE China. The host rocks consist of muscovite monzonitic granite (MMG) and biotite granitic porphyry (BGP), which are intruded into Lower and/or Middle Jurassic intermediate-felsic volcanic-sedimentary rocks and pre-ore monzogranitic porphyry (MP). Zircon laser ablation−inductively coupled plasma−mass spectrometric (LA-ICP-MS) U-Pb age dating indicates that the MMG and BGP were emplaced at 144.9 Ma and 144.7 Ma, ca. 14 m.y. younger than the intrusion age of MP (159.3 Ma). Molybdenite Re-Os isotopic dating indicates that Mo mineralization occurred at 144.9 Ma, almost simultaneously with the 145 Ma magmatic activity. Geochemically, all of the Ulgen granitoids are enriched in large ion lithophile elements (e.g., Rb, Th, U, and K) and light rare earth elements, and are depleted in high field strength elements (e.g., Nb, Ta, and Ti). The pre-ore MPs belong to I-type granites with moderately negative Eu anomalies (Eu/Eu* = 0.62−0.65), whereas the syn-ore MMGs exhibit S-type affinity with pronounced negative Eu anomalies (Eu/Eu* = 0.29−0.39). The ore-forming BGPs display adakite-like geochemical features in terms of high-Sr, low-Y, and low-Yb contents, and slightly negative Eu anomalies (Eu/Eu* = 0.72−0.74). All intrusive rocks have relatively low initial (87Sr/86Sr)i ratios (0.7044−0.7055) and positive εNd(t) values (+1.15 to +2.65), positive εHf(t) values (+4.0 to +9.4), young two-stage Nd and Hf model ages (tDM2(Nd) = 841−731 Ma, tDM2(Hf) = 943−604 Ma), and moderate (206Pb/204Pb)i (18.300−18.402), (207Pb/204Pb)i (15.557−15.564), and (208Pb/204Pb)i (38.180−38.307) ratios. Therefore, it is most likely that these intrusive rocks originated from a mixture of two sources of magma derived from the mantle and juvenile lower crust, in which there were variable degrees of the fractional crystallization of ilmenite, apatite, and plagioclase. Rather than the partial melting of oceanic slabs, the fractional crystallization of hornblende and accessory minerals (e.g., ilmenite and apatite) induces the adakitic geochemical signature of BGPs. Compared with the BGPs, the MPs had a relatively deeper magma source region, whereas the MMGs had a relatively shallower magma source region. The BGPs and the Mo-bearing fluids of the Ulgen deposit were most probably derived simultaneously from magma that was generated at an extensional setting following the closure of the Mongol-Okhotsk Ocean during the latest Jurassic. Enrichment of Mo by late-stage fractional crystallization most likely played an important role in concentrating Mo during the formation of the Ulgen hidden Mo deposit.