We present shear wave splitting results obtained from the analysis of core-refracted teleseismic phases recorded by permanent and temporary seismographic stations located in the Victoria Land region (Antarctica). We use an eigenvalue technique to isolate the rotated and shifted shear wave particle motion, to determine the best splitting parameters. Average values show clearly that dominant fast axis direction is NE–SW oriented, in accordance with previous measurements obtained around this zone. Only two stations, OHG and STAR, show different orientations, with N–S and NNW–SSE main directions. On the basis of the periodicity of single shear wave splitting measurements with respect to backazimuths of events under study, we infer the presence of lateral and vertical changes in the deep anisotropy direction. To test this hypothesis we model waveforms using a cross-convolution technique for the cases of one and two anisotropic layers. We obtain a significant improvement on the misfit in the double layer case for the two stations. For stations where a multilayer structure does not fit, we investigate lateral anisotropy changes at depth through Fresnel zone computation. We find that anisotropy beneath the Transantarctic Mountains (TAM) is considerably different from that beneath the Ross Sea. This feature influences the measurement distribution for the two permanent stations TNV and VNDA. Our results show a dominant NE–SW direction over the entire region, however other anisotropy directions are present and maybe interpreted in the context of regional tectonics.
We present shear-wave splitting results obtained from analysis of core refracted teleseismic phases recorded by permanent and temporary seismographic stations located in the Victoria Land region (Antarctica). We used eigenvalue technique to linearize the rotated and shifted shear-wave particle motion, in order to determine the best splitting parameters. A well-scattered distribution of single shear-wave measurements has been obtained. Average values show clearly that dominant fast axis direction is NE-SW oriented, accordingly with previous measurements obtained around this zone. Only two stations, OHG and STAR show different orientations, with N-S and NNWSSE main directions. On the basis of the periodicity of single shear-wave splitting measurements with respect to back-azimuths of events under study, we inferred the presence of lateral and vertical changes in the deep anisotropy direction. To test this hypothesis we have modelling waveforms using a cross-convolution technique in one and two anisotropic layer’s cases. We obtained a significant improvement on the misfit in the double layer case for the cited couple of stations. For stations where a multi-layer structure does not fit, we looked for evidences of lateral anisotropy changes at depth through Fresnel zone computation. As expected, we find that anisotropy beneath the Transantarctic Mountains (TAM) is considerably different from that beneath the Ross Sea. This feature influences the measurement distribution for the two permanent stations TNV and VNDA. Our results show a dominant NESW direction over the entire region, but other anisotropy directions are present and find an interpretation when examined in the context of regional tectonics.
We present shear-wave splitting results obtained from analysis of core refracted teleseismic phases recorded by permanent and temporary seismographic stations located in the Victoria Land region (Antarctica). We used eigenvalue technique to linearize the rotated and shifted shear-wave particle motion, in order to determine the best splitting parameters. A well-scattered distribution of single shear-wave measurements has been obtained. Average values show clearly that dominant fast axis direction is NE-SW oriented, accordingly with previous measurements obtained around this zone. Only two stations, OHG and STAR show different orientations, with N-S and NNWSSE main directions. On the basis of the periodicity of single shear-wave splitting measurements with respect to back-azimuths of events under study, we inferred the presence of lateral and vertical changes in the deep anisotropy direction. To test this hypothesis we have modelling waveforms using a cross-convolution technique in one and two anisotropic layer’s cases. We obtained a significant improvement on the misfit in the double layer case for the cited couple of stations. For stations where a multi-layer structure does not fit, we looked for evidences of lateral anisotropy changes at depth through Fresnel zone computation. As expected, we find that anisotropy beneath the Transantarctic Mountains (TAM) is considerably different from that beneath the Ross Sea. This feature influences the measurement distribution for the two permanent stations TNV and VNDA. Our results show a dominant NESW direction over the entire region, but other anisotropy directions are present and find an interpretation when examined in the context of regional tectonics.
The Val d’Agri (VA) oilfield in the Lucanian Apennines (southern Italy), represents the largest onshore in Europe. Since the 1990's, hydrocarbons are produced from a fractured carbonate reservoir with an average extraction rate of 7*104 barrels/day of oil and 3*106 Smc/day of gas. Part of the wastewater has been re-injected since 2006 into a marginal portion of the reservoir by a high-rate well (Costa Molina 2, CM2). Charged by the Italian oil and gas safety authority, the National Institute of Geophysics and Volcanology (INGV) monitors the VA industrial hydrocarbon operations through the research activity of a dedicated working group (CMS, Centro di Monitoraggio del Sottosuolo) and according to the governmental monitoring guidelines. The CMS operates the real-time acquisition and offline analyses of seismic data recorded at 56 seismic stations associated with public and private local seismic networks. The principal aim of the CMS is to investigate the risk associated with industrial activities that can induce or trigger seismic events by producing stress changes within the upper crustal volume. Previous works have highlighted a spatio-temporal relationship between micro-seismicity (ML ≤ 2.2) and wastewater injection, delineating a NE-dipping back-thrust near the CM2. Part of the microseismicity recorded in the southwestern portion of the VA has also been associated with the water level changes of the Pertusillo lake. One of the main challenges is to define an accurate structural setting of the VA to understand the potential of earthquakes in the area and investigate the presence of active faults. The VA consists of a Quaternary extensional tectonic basin and it is one of the areas of highest seismic hazard in Italy (Basilicata, 1857, M7 earthquake). The basin is bounded by two parallel and oppositely dipping normal fault systems: the Monti della Maddalena Fault System (MMFS) on its western side and the Eastern Agri Fault System (EAFS) on the eastern one. The characterization of the ongoing tectonic activity of the MMFS and EAFS, and their hierarchical relationship is still generating debate among the scientific community. We adopt a multidisciplinary approach based on detailed geological-structural, geophysical and seismic analyses, and electrical resistivity tomography, aimed at reconstructing the subsurface geology of the area and recognizing and characterizing the active and capable faults, and the associated potential for local seismic hazard. We present and discuss the results of this work, focusing on the relative location of seismic events that occurred between March and June 2022. The outcomes allow inferring interesting geologic constraints, highlighting the relationships between the distribution of local seismicity and the structural setting of the area in the uppermost crust (depth < 6 km).
SUMMARY We infer seismic azimuthal anisotropy from ambient-noise-derived Rayleigh waves in the wider Vienna Basin region. Cross-correlations of the ambient seismic field are computed for 1953 station pairs and periods from 5 to 25 s to measure the directional dependence of interstation Rayleigh-wave group velocities. We perform the analysis for each period on the whole data set, as well as in overlapping 2°-cells to regionalize the measurements, to study expected effects from isotropic structure, and isotropic–anisotropic trade-offs. To extract azimuthal anisotropy that relates to the anisotropic structure of the Earth, we analyse the group velocity residuals after isotropic inversion. The periods discussed in this study (5–20 s) are sensitive to crustal structure, and they allow us to gain insight into two distinct mechanisms that result in fast orientations. At shallow crustal depths, fast orientations in the Eastern Alps are S/N to SSW/NNE, roughly normal to the Alps. This effect is most likely due to the formation of cracks aligned with the present-day stress-field. At greater depths, fast orientations rotate towards NE, almost parallel to the major fault systems that accommodated the lateral extrusion of blocks in the Miocene. This is coherent with the alignment of crystal grains during crustal deformation occurring along the fault systems and the lateral extrusion of the central part of the Eastern Alps.
SUMMARY To constrain seismic anisotropy under and around the Alps in Europe, we study SKS shear wave splitting from the region densely covered by the AlpArray seismic network. We apply a technique based on measuring the splitting intensity, constraining well both the fast orientation and the splitting delay. Four years of teleseismic earthquake data were processed, from 723 temporary and permanent broad-band stations of the AlpArray deployment including ocean-bottom seismometers, providing a spatial coverage that is unprecedented. The technique is applied automatically (without human intervention), and it thus provides a reproducible image of anisotropic structure in and around the Alpine region. As in earlier studies, we observe a coherent rotation of fast axes in the western part of the Alpine chain, and a region of homogeneous fast orientation in the Central Alps. The spatial variation of splitting delay times is particularly interesting though. On one hand, there is a clear positive correlation with Alpine topography, suggesting that part of the seismic anisotropy (deformation) is caused by the Alpine orogeny. On the other hand, anisotropic strength around the mountain chain shows a distinct contrast between the Western and Eastern Alps. This difference is best explained by the more active mantle flow around the Western Alps. The new observational constraints, especially the splitting delay, provide new information on Alpine geodynamics.
