The Palaeo‐Tethys is known to have diverged into several splays throughout East and South‐east Asia. Several researchers have widely studied the importance and geometries of the Palaeo‐Tethys' branches. Plate reconstruction geometries for the southern Palaeo‐Tethys splay suggest that the ocean either connects to the proto‐Pacific or dies out. We review and discuss the Late Palaeozoic to the Early Mesozoic lithologies attributed to the Palaeo‐Tethys, from the Himalayan Syntaxis in the north to the Bangka and Belitung islands in western Indonesia to the south. Relics of oceanic crust and deep‐sea sediments related to the main Palaeo‐Tethys Basin can be traced from the South China (Yunnan)‐Thailand border to Peninsular Malaysia. A sub‐parallel back‐arc suture exists in eastern Thailand in the north and vanishes towards the south at the latitude of the Gulf of Thailand. Towards the south of Peninsular Malaysia, the material that constitutes the suture zone of main Palaeo‐Tethys is found offshore in the Riau Archipelago, Indonesia, and has been extensively eroded. Thus, we rely on gravity signatures to extrapolate the extension of the structures to the Bangka and Belitung islands, which show only minor serpentine and pillow basalts occurrences along a line that curves towards Borneo. The metamorphic rocks associated with the suture zones range from high grade (gneiss) in Thailand to low grade (mica schist and minor amphibolite) in Peninsular Malaysia. The syn‐ and post‐collisional granitic bodies that form large batholiths in Thailand and Malaysia are comparatively smaller in Indonesia, particularly on Belitung Island, suggesting the lack of large underplating of the Sibumasu crust within the region. We interpret the stratigraphic and tectonic observations of the southern Palaeo‐Tethys to support the theory of the southward (present orientation) opening of a propagating oceanic basin from Devonian to Carboniferous, which began to close from the Permian to Triassic period.
Fission tracks are linear trails of intense radiation damage in the crystal structure of a mineral, produced by spontaneous fissioning of uranium-238 (238U) atoms. Detail information on the low-temperature thermal histories of rocks, below∼120 °C for tracks in apatite and below∼350 °C for zircon, can be provided by Fission-track (FT) analysis. The purpose of this article is to present apatite and zircon fission-track data, and U–Pb granite ages that provide information about the cooling histories of a rock which can be crucial in comprehending the exhumation episodes of the study area, in particular, and the region, in general. Granite samples were collected along the same vertical profile at different elevation, 178–944 m.a.s.l. These samples were used to determine Fission-Track and crystallization ages. HeFTy software was employed to interpret the cooling histories of the samples using forward and inverse models. The inverse model was an approach of reproducing the observed data, and it was carried out only for fission-track data from the apatite grains. And it was constructed after generating a number of forward models, where in each of these models the predicted apatite fission-track parameters were compared to the measured values. The apatite fission track (AFT) and zircon fission track (ZFT) data indicated expected age trends, i.e. the older ages at higher elevations and the younger ages at lower elevations. Similarly, the data shows that the apatite and zircon FT ages appear younger than the age of the rock crystallization. The U–Pb age in zircon consistently suggest the age of the granite is Late Triassic.